Here you can get information about How do I reset my Netgear Wi-Fi Extender. A factory reset deletes all personalized settings including your username, password, network name (SSID), and security settings.
A factory reset is necessary when you cannot recover your Wi-Fi range extender’s admin password. A factory reset prepares your device for a new installation.
To perform a factory reset on your NETGEAR Wi-Fi extender:
- Plug in your extender.
- If the Power LED does not light, press the Power or On/Off button.
- The Power LED lights.
- Wait for the LEDs on your extender to stabilize. This can take a few minutes.
- Locate your extender’s Reset or Factory Reset button. The button is usually located on the extender’s side or bottom panel behind a small hole.
- Use a straightened paper clip or similarly sized object to press and hold the Reset or Factory Reset button until the Power LED blinks.This can take up to 10 seconds.
Reset a Netgear EX2700 Wi-Fi Repeater Using a Web Browser
- Connect to your range extender’s Wi-Fi network.
- Open a web browser of your choice on the device you’re using.
- Navigate to the following address:
- Enter the password when requested.
- On the Netgear Genie page, Click the Menu icon, Settings, and then Other Settings.
- Click on Reset.
- Press OK.
- Your range extender will begin to reboot and will perform a full factory reset.