In this post, you can know about How To Reset HP Toner Cartridge Chips easily. HP printers are some of the most reliable and good quality printers available in the market.

However, technical issues may be experienced by HP printer users, especially in the outdated versions of the devices. Even the most reliable of printers will occasionally let you down, so knowing a few basic troubleshooting skills can get you out of a jam when the printer is playing up.

Steps to Reset HP Toner Cartridge Chips

Step 1: Switch the printer off.

Step 2: Press and hold the green button on your printer and turn the printer on. You will see that the lights flash for a moment and then turn off. After a few seconds, the attention light will turn on, followed by the ready light and the green light. Keep pressing the green button. In a few seconds, the attention light and the ready light will turn off.

Step 3: Push the toner rotate button while you continue pressing the green button. As you briefly push the toner button, you will see the light flashing. Release both the toner button and the green button.

Step 4: Repeatedly push the red button (cancel button). Now all the working lights on the printer will turn off.

Step 5: Open and close the lid of HP printer once. The light will start blinking.

Step 6: Press the green button. Your HP toner cartridge chip will be reset.

How to Reset an HP Toner Smart Chip

Step 1: Power your HP LaserJet printer off via the power switch, which is usually located on the side or rear of the printer. Do not disconnect power to the printer.

Step 2: Press and hold the printer’s “Go” button on the main control panel, which is located on top of the printer. On some models, this button will be labeled “Go,” while on other models, it will appear as a green button with a check mark on it.

Step 3: Power on the printer via the power switch, while still holding down the “Go” button. After a few seconds, the display screen on the printer will read “Cold Reset.” Continue pressing the “Go” button. You will hear the printer’s motors rotating inside the machine. On some models, “Cold Reset” may not be displayed on the screen, but according to HP, hearing the motors rotating is indicative that the reset was successful.

Step 4: Release the “Go” button. The display screen will then read “Initializing,” then “Restoring Factory Settings.” Lastly, the display will read “Offline.”

Step 5: Press the “Go” button once again to bring the printer back online. If the Smart Chip was malfunctioning, it should now be reset and printing functionality will be restored to your HP laser printer.

If the screen still indicates that the toner cartridge needs to be replaced, it is likely that it is out of toner.